| Message: | Description of ceramic plunger mud pump:
Ceramic plunger mud pump is designed and manufactured by American Block our K-Series mud pumps and are ideally suited for all drilling applications. They range from 800 to 2200 HP and exceed the quality and performance for other mud pump manufactures. For deep drilling performance or maximum efficiency, K-Series pumps provide the best power to weight ratios and the smallest footprint in the industry.
Manufactured for continuous operation at maximum working pressure each pump incorporates; an inherently balanced forged-steel crankshaft to minimize wear, noise and, vibration. Also each pump is fully load tested to ensure quality and performance.
using tips of ceramic plunger mud pump:
(1), before starting the preparation work: check the fastening of each component; check oil tank oil level, oil level height to oil tank oil window engraved line, summer with N46, in winter with N32 hydraulic oil. The same type of anti-wear hydraulic oil is applied to high pressure pumps and over 140 pumps. Check pressure gauge range, hydraulic station pressure gauge 0 - 16MPa, air tank pressure gauge range should be 0 - 6MPa, can not be reversed.
(2), start: turn on the cooling water; switch on, turn on the switch, start the press button, check the steering of the motor. It should be clockwise and must not be reversed. After the inspection is unmistakable, the motor and the oil pump are restarted.
(3), operation regulation: (1), adjust the overflow valve can adjust the oil pressure, can adjust the mud pressure, the adjustment of the overflow valve should be locked on the lock nut, every time the shutdown does not move the overflow valve, oil pressure should not be higher than 12MPa. Explanation: the quantitative pump should be started at low load, if two pumps are used alternately, it can be stopped first and then start, without adjusting the overflow valve; (2), adjust the position of two wheel on the sliding frame, and adj......url:http://www.ztmineequipment.com |
my account