| Message: | Kuplin is from a Russian hydraulic equipment manufacturing company, he has purchased hydraulic valve blocks from China for a long time, which is also relatively smooth. However, a hydraulic valve block he purchased at the end of last year put him into a hard situation.
A batch of hydraulic climbing cars sold by their company were complained by customers. During the routine maintenance of the hydraulic system, several cartridge valves on several equipment cannot be taken down, the nose end is stuck in the socket of the hydraulic valve blocks, and there is a small amount of leakage around the socket. The hydraulic valve block manufacturer replied that when processing the hydraulic valve blocks, the technician processed the nose end of the socket into a conical surface, which made it easy to install and difficult to take down, and also affected the seal, resulting in a small amount of leakage. The hydraulic valve block can be replaced free of charge, but no one will bear the loss of those hydraulic cartridge valves that cannot be disassembled. After the boss learned that, he asked Kuplin to find a new manufacturer of hydraulic valve blocks. Kuplin contacted more than 10 new factories and required that there was no abnormality in the processing of valve holes of each hydraulic valve block. After a round, he did not find any suitable supplier of hydraulic valve blocks. Kuplin began to worry.
|
my account