| Message: | II. Main technical specifications and parameters
1. Power supply: AC 220V (-5%~10%), 50 Hz
2. Measurement range: 5.0°C~90±0.5°C; or 5.0°C~75±0.5°C
(You should use low temperature water for measurement at 5.0°C
ambient temperature)
3. Temperature resolution: 0.01°C
4. Stirrer: Its speed can be continuously adjusted
5. Heating rate: It will be 5.0±0.5°C/min after 3 minutes in the
measurement state
6. Heating power: 800 W;
7. Cubage of beaker: 1000 ml
8. Environment: The working temperature should be lower than 35°C
and keep stable and without air convection.
9. Relative humidity: no more than 85%
10. Total power consumption: no more than 850 W
III.More softening point tester
DSHD-2806E Asphalt Softening Point Tester
DSHD-2806F Asphalt Softening Point Tester
DSHD-2806G Automatic Asphalt Softening Point Tester
DSHD-2806H Automatic Asphalt Softening Point Tester
DSHD-2806I Fully-automatic Asphalt Softening Point Tester
DSHD-2806J Fully-automatic Asphalt Softening Point Tester
DSHD-2806 Asphalt Softening Point Tester |
my account
