| Message: | The advantages of the diamond dressing roller are as below:
1. High production efficiency, long service and work life, low dressing cost for a single grinding wheel
2. Ensure the precision of workpieces, stable roughness, reduce the inferior products largely
3. Dressing equipment is of simple structure, change less, reduce workload of operators.
How to dressing diamond dressing roller?
DRESSING : Bring diamond to high point of grinding wheel. Turn on coolant. See that acopious amount is flowing on both diamond and wheel. Start traverse feed 18" to 30" perminute. Take two or more passes across face of wheel. (Stop here if rough dressing isdesired). To obtain finish dressing, continue from above. Change traverse fee to 6" to 15" perminute. Proceed with at least 2 passes at .001" penetration followed by one or two passes at.0005" penetration. (Stop here for good commercial finish). For super finish continue with oneor two passes without further penetration. Remove loose particles from face of wheel by using a small piece of hard wood or fiber.
diamond dressing roller
Diamond dresser should be on the center line of grinding wheel or 1/32" below, never above.
To avoid wheel taper, position diamond dresser as near as possible to the area where the grinding is being performed. When completing last pass of dressing operation allow same to finish in the same direction each time.
More information about electroplated tools , please check the below link:
http://www.moresuperhard.com/4/Electroplated-diamond-CBN-grinding-wheels.html
TEL: 0086-371-86545906 e-mail: anna.wang@moresuperhard.comAre you interested in tool |
my account
