Message: | It is important that the technician refer to the troubleshooting information furnished by the manufacturer.
(1) Relief valves repair... lack of pressure in a system can be caused by a sheared Torque wrench pump shaft, defective relief valves needing repair
(2) If a system fails to hold pressure in the pressure section, the likely cause is the pressure regulator, an unloading valve, leaking relief valves nedding repair, or a leaking check valve.
(3) If the pump fails to keep pressure up during operation of the subsystem, the pump may be worn or one of the pressure-control units may be leaking.
(4) High pressure in a system may be caused by a defective or improperly-adjusted pressure regulator, an unloading valve, or by an obstruction in a line or control unit.
(5) Unusual noise in a hydraulic system, such as banging and chattering, may be caused by air or contamination in the system. Such noises can also be caused by a faulty pressure regulator, another pressure-control unit, or a lack of proper accumulator action.
Aviation component repair.
Overhaul of hydraulic and pneumatic units is usually accomplished in approved repair facilities; however, replacement of seals and packings may be done from time to time by technicians in the field. When a unit is disassembled, all O-ring and Chevron seals should be removed and replaced with new seals.
When installing seals, care should be exercised to ensure that the seal is not scratched, cut, or otherwise damaged. When it is necessary to install a seal over sharp edges, the edges must be covered with shim stock, plastic sheet, or electrical tape.
Torque wrench pump range from the most common household types to specialty types.Check out the website that specializes in wrenches at https://www.atwwren.com for details.
Or contact us
Company Name: Hang Zhou WREN Hydraulic Equipment Manufacturing Co., Ltd.
Address: No. 24, Xingxing Road, Linping, Hang Zhou, China
Tel: +86 571 8811 5720
Fax: 0571-88110210
Postcode: 311100
E-mail:info@wrenchina.com
|