L0730 eco duct rodder Vendor

Create: 02/26/2016

Expired Date:	never
Category:	Components [Electronic]
Message:	Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.







City:	Langfang[CN]
Location:

May 27 2016	X-I/II/III railway electrification wire grip	711
May 27 2016	X-II German-style wire pliers,new type German-style wire grip	717
May 27 2016	X-I/II/III German-style wire grip,breaststroke wire grip	699
May 27 2016	SKGF-6/8/10 anti-twist rope wire grip, clips	715
May 27 2016	SKGF-2/3/5 bolt type wire grip, anti-twist rope wire grip	721
May 27 2016	SKG-10 round strand wire rope clips	703
May 27 2016	SKG-7 bolt type wire rope clips	714
May 27 2016	SKG-4 round strand wire rope clips,wire rope grip	700
May 27 2016	SKG-200N wire rope pliers	727
May 27 2016	SKG-120N wire grip,anti-twist rope wire grip	712