L06S50 PLASTIC STEEL cobra solid rod

Create: 02/28/2016

Expired Date:	02/16/2017
Category:	Electronic
Message:	Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.






City:	Hebei[CN]
Location:

Aug 24 2016	BZ-65C/85C/105C electric Powered Cable Cutter	762
Aug 24 2016	BZ-65C/85C/105C hydraulic battery armoured CableCutter	781
Aug 24 2016	BZ-65C/85C/105C Battery powered cutter for Cu/Alcable	758
Aug 24 2016	BZ-65C/85C/105C Battery Powered Cable Cutter for Al/Cu cable	788
Aug 24 2016	CPC-65C/85C/105C/120C Hydraulic Wire CableCutting tool Head	760
Aug 24 2016	CPC-65C/85C/105C/120C Hydraulic Wire CableCutting Head	757
Aug 24 2016	CPC-65C/85C/105C/120C Cable Cutting Head for Cu Alcable	767
Aug 24 2016	HZ-65C/85C/105C armoured Cu/Alu cable cutter	763
Aug 24 2016	HZ-65C/85C/105C Hydraulic cable Cutter	770
Aug 24 2016	HZ-65C/85C/105C Hydraulic Cu/Al Cable Cutter	752